Controllers: SLPIR Wireless Controller

SLPIR Wireless Controller (Motion Activated Run-back Timer)

Once activated from up to 5 metres, the controller allows the heater to increase the room temperature to its designated comfort setting.

If no movement is detected by a predetermined time the heater is either switched off or the temperature can be held at a lower background level. The SLPIR controller is designed to control multiple SL heaters or SL receivers within the RF signal range.

  • Can operate multiple SL heaters or SL receivers
  • Motion sensor range of up to 5 metres
  • Detection area: 60 degrees vertical, 120 degrees horizontal
  • Controller acts as a run-back timer where a full heating period is activated when the controller detects movement
  • Choice of 4 time periods: 5, 15, 30 and 60 minutes
  • Comfort heat setting between 15°C to 35°C
  • Setback temperatures can be used for frost protection or maintaining a minimum room temperature 0°C to 15°C
  • 4 segment light indicator which counts down the time
  • Easy operation
  • Fits onto most standard single gang box
  • External input available to connect to any voltage free contact such as timers or BMS
  • Can be powered by either mains 240V or 12VDC which allows SELV (Separated Extra Low Voltage) installation*

* Power adapter not supplied.

SLPIR’s Operating Mode

When a movement is detected, all the indicator segments will light up and the heating is activated for a set period of time. If no movement is detected by a predetermined time, the heater is either switched off or the temperature can be held at a lower background level.

SLPIR Timer Mode with time period segments:

  SLPIR detects movement
Time segments (minutes) Full heating period activated (minutes)
5 20
15 60
30 120
60 240

Dimensions & Specifications

Dimensions:

Height (mm) Depth (mm) Width (mm)
86 26 85